|
The
Dark Sucker Theory
For years, it has
been believed that electric bulbs emit light, but recent information has proved
otherwise. Electric bulbs don't emit light; they suck dark. Thus, we call these
bulbs Dark Suckers. The Dark Sucker Theory and the existence of dark suckers
prove that dark has mass and is heavier than light.
First, the basis
of the Dark Sucker Theory is that electric bulbs suck dark. For example, take
the Dark Sucker in the room you are in. There is much less dark right next to
it than there is elsewhere. The larger the Dark Sucker, the greater its capacity
to suck dark. Dark Suckers in the parking lot have a much greater capacity to
suck dark than the ones in this room.
So with all things,
Dark Suckers don't last forever. Once they are full of dark, they can no longer
suck. This is proven by the dark spot on a full Dark Sucker. The dark which has
been absorbed is then transmitted by pylons along to power plants where the machinery
uses fossil fuel to destroy it.
A candle is a primitive
Dark Sucker. A new candle has a white wick. You can see that after the first
use, the wick turns black, representing all the dark that has been sucked into
it. If you put a pencil next to the wick of an operating candle, it will turn
black. This is because it got in the way of the dark flowing into the candle.
One of the disadvantages of these primitive Dark Suckers is their limited range.
There are also
portable Dark Suckers. In these, the bulbs can't handle all the dark by themselves
and must be aided by a Dark Storage Unit. When the Dark Storage Unit is full,
it must be either emptied or replaced before the portable Dark Sucker can operate
again.
Dark has mass.
When dark goes into a Dark Sucker, friction from the mass generates heat. Thus,
it is not wise to touch an operating Dark Sucker. Candles present a special problem
as the mass must travel into a solid wick instead of through clear glass. This
generates a great amount of heat and therefore it's not wise to touch an operating
candle.
This is easily
proven for lightbulbs too. When you compress a gas, it gets hot, right? So the
light bulb gets hot because of all the dark being squished into the wires.
Also, dark is heavier
than light. If you were to swim just below the surface of the lake, you would
see a lot of light. If you were to slowly swim deeper and deeper, you would notice
it getting darker and darker. When you get really deep, you would be in total
darkness. This is because the heavier dark sinks to the bottom of the lake and
the lighter light floats at the top. The is why it is called light.
Dark Suckers are
only able to suck dark in a straight line. Dark, because of its mass, will not
penetrate solid, opaque objects as it is being sucked by a Dark Sucker. When
a Dark Sucker is operating, you will notice that dark that is behind a solid,
opaque object does not flow through the object or around it to the Dark Sucker.
Some of the dark will accumulate on the side of the object away from the Dark
Sucker as the Dark Sucker attempts to pull it through the object. These residual
patches of dark are often referred to as `shadows.'
Some surfaces are
able to function as secondary Dark Suckers by sucking the dark from behind solid
objects at an angle and then rerouting it to the primary Dark Sucker. These surfaces
have a property we refer to as `reflective.'
Finally, we must
prove that dark is faster than light. If you were to stand in a lit room in front
of a closed, dark closet, and slowly opened the closet door, you would see the
light slowly enter the closet. But since dark is so fast, you would not be able
to see the dark leave the closet.
So next time you
see an electric bulb, remember that it is not a light emitter but a Dark Sucker.
|